Builds: Lites Class Yamaha Superjet
Check out as we build the IJSBA legal Lites Class Two Stroke 2015 Yamaha Superjet!
Builds: Krash 50 Cal Footrocket
Started life as a stage 2 kit, but I replaced the Kavinci pump and trim setup with stainless 148 setback Torrent pump and RRP trim, quality Yamaha components. Quality Yamaha based engine.
-Group K 845
-Factory Pipe B pipe with limited chamber, ported matched to cylinder by Group K
-Assembled with brand new 144 Mikuni carbs
-H2O Designs 3gal tank w/built in battery holder
-Torrent Setback 12 vane 148mm SS MAG pump setup for dual cooling
-Setback SJ driveshaft
-Medium billet pump cone
-Skat D-75 Big Hub Impeller
-RRP 144-148mm complete trim system
-OEM SJ midshaft housing
-OEM pump shoe and seal
-OEM RN midshaft
-ADA coupler
-OEM mounts
-Fresh ebox rebuild when assembled
-Fresh starter & bendix this season
-OCD Solutions plug wires
-OCD Solutions tidy bilge wiring
-Rule 500 bilge pump
-Replaced faulty hood seal with formed silicone seal. Looks ugly, but actually works.
-Versiplug
Check out the 17 Part Playlist below!
Builds: ProForce 2.0
Chris at Pro Watercraft Racing has put in countless hours, research, and detail into developing a completely new aftermarket racing stand up jet ski hull. That effort shows in the quality carbon & fiberglass work, how accurately everything lines up, and most importantly – how the ski performs on the race course.
Stephen’s ProForce 2.0 features:
Full carbon fiber build with a visual carbon center
Bottom hull formed for Kawasaki 1500cc four stroke power plant
Medium metal flake paint
Custom Jettrim mats
Optional rear fuel tank
Front F1 inspired bumper
Ultra handlepole
Dual exit exhaust
In mid-July 2019 the Pro Watercraft Racing ProForce showed up in our driveway in the back of a coworker’s SUV, after travelling in a different coworker’s trailer from Havasu to Houston. Thanks ya’ll!
Work has been slow to start on this Pro Watercraft Racing handmade beauty, but with the addition of a garage AC unit the Texas heat has been bearable.
Chris at Pro Watercraft Racing flew down and hung out with us for a day. In the videos below you can see the silver ProForce 2.0, above coworker’s built right before my husband’s, in action as well as getting the engine installed. There are A LOT of ProForces in Texas that’s for sure!
So far we’ve managed to get the pump, midshaft bearing, and engine aligned. Fuel tank, engine, and exhaust manifold installed. Oh – and can’t forget the Ferrari Red wrinkle powder coated valve cover. Yeah…he likes the color red if you hadn’t guessed.
Check out the videos below for the build chronicles 😉
Hello world!
Welcome to WordPress. This is your first post. Edit or delete it, then start writing!